ووتر ستوب
SAB® TRON INSULATION SYSTEM™:
Supply and apply of approved quality waterproofing system for roof (Combo Roofing System) all in according with the drawing and specification:-
1- Polyurethane foam BASF/ B3-F, 40-45 mm thick and density 45 Kg/m3 .
2- SAB® Bitumen Rubberized - Liquid protection coat (600 mic.Thick).
3- Geotextile /Separation Layer 100 g/m2.
4- Filler board/flexible sheet & cement stand mortar.
5- Concrete screed (25N / MM - 350 OPC, 70 MM AVE. Thick.) without ice.
6- Angle fillet (cement sand mortar and SBR bonding agent).
7- Expansion joint filler (Backing rod + Pu sealant).
8- Acrylic Top coat final with primer.
- Terms & Conditions
- الأسعار باستثناء ضريبة القيمة المضافة
- الأسعار باستثناء تكاليف التسليم.
-
Delivery: 2 working days, (Weekend Friday, Saturday and Sunday)
DIRECTIONS FOR USE
1) Apply PENEBAR™ PRIMER by using brush at a minimum of 0.1 mm (4 mils) thick by 50 mm (2”) wide over the entire surface length to receive PENEBAR™ SW-45 Rapid. Allow it to dry for 10-15 minutes at a temperature of 25°C (77°F) or, where the temperatures are low, allow it to dry for a longer time. 2) By using the heel of the hand and moderate pressure, press a bead of PENEBAR™ SW-45 Rapid firmly into position on the standing structure. Make sure the product has bonded with the primed area. 3) Where required, splice ends to form a continuous, uninterrupted seal. For best results, cut each end at opposite 45° angles and tightly butt ends together. DO NOT OVERLAP ENDS. Gently knead the spliced ends creating an uninterrupted seal. 4) Peel the protective covering from the exposed side of the installed PENEBAR™ SW-45 Rapid. 5) Follow standard concrete placing procedures from here onwards
