PENEPLUG® Crystalline Waterproofing Rapid Set Waterplug
PENEPLUG® is a rapid setting, integral crystalline cementitious waterstop designed to stop active water leaks and moisture ingress.
-
تاريخ الشحن المقدر 2-3 أيام
- دفع عند الاستلام
- دفع اونلاين
- الأسعار باستثناء ضريبة القيمة المضافة
- الأسعار باستثناء تكاليف التسليم.
- التسليم عن طريق ساب غيت
-
Terms & Conditions
PENEPLUG®
CRYSTALLINE WATERPROOFING RAPID SET WATERPLUG
DESCRIPTION
PENEPLUG® is a rapid setting, integral crystalline
cementitious waterstop designed to stop active water
leaks and moisture ingress. PENEPLUG® can be
used internally or externally as a waterproof plugging
mortar or where rapid setting and early strength gain
is required.
APPLICATIONS
Concrete
Masonry
Earthenware
Stone
ADVANTAGES
Plugs/stops active water leaks
Seals leaking joints, form tie holes or cracks
Sets in approximately 30 seconds after mixing
Durable
Can be used underwater
Can be mixed with water or used dry
Easy to apply
Zero VOC - PENETRON powdered products contain
zero volatile organic compounds and are safe for use
both outdoors and in confined indoor spaces
Application:
To avoid waste, only small quantities of PENEPLUG® should be mixed. After mixing, apply PENEPLUG® to the appropriate area immediately. Material should be formed into a wedge and forced into the leak. This can be accomplished with the use of a block of wood and hammer. Work the plug well into the area and then, applying as much pressure as possible, hold firmly in place for about 30 seconds or until set. After the leak has stopped, prime the area with a bond coat of PENETRON® and then fill the remaining void to the surface with PENECRETE MORTAR™. Remove excess material. After lightly pre-wetting, apply a final coat of PENETRON® to the repaired area. In certain circumstances, PENEPLUG® may be applied as a dry powder. After preparing the surface as described above, place and hold the powder directly over the leak for 30-60 seconds.